SIP for callshops
SIP pour les teleboutiques
  Home | Rates | Configuration | F.A.Q | Contact us | Signup | Login FranšaisEspa˝olDeutschItaliano
Call shop VoIP

This page explains how to use the Sipura range of devices to access SIP Boutique.  The Linksys PAP2 uses the same firmware, so these instructions also apply to that device.

  • Free billing system

    Free call shop billing system

Logging in

  • Log on the the Admin page of the Sipura using the following URL format: http://a.b.c.d/admin/, where a.b.c.d is the Sipura's IP address.
  • Click on the Advanced link on the top left of the configuration page.

SIP

Click on the SIP tab at the top of the page.  Change this setting in the SIP Timer Values section:

SIP T1:    1.5

Lines

Configure all lines as follows:
  • NAT settings
    • NAT Keep Alive Enable = No
  • Proxy and Registration
    • Proxy = sip.sipboutique.com
    • Outbound proxy = [blank]
    • Register = Yes
    • Use Outbound proxy = No
    • Make Call Without Reg = No
    • Answer Call Without Reg = Yes
  • Subscriber information
    • User ID = [Any number.  Each booth must have a unique number.]
    • Password = [Your SIP Boutique password]
    • Auth ID = [Your SIP Boutique account number]
    • Use Auth ID = Yes
  • Supplementary Service Subscription
    • Three Way Call Serv = No
  • Audio Configuration
    • G729a Enable = No.  (If you are only using one port on the device, you can set this for "Yes" for improved audio quality.  But, the Sipura only allows one concurrent Low Bitrate Call when this codec is enabled.)
    • DTMF Tx Method = INFO
    • Hook Flash Tx Method = INFO
Home | Rates | Configuration | F.A.Q | Contact us | Signup | Login

Last modified: 13 June 2016

Copyright ę 2016. All rights reserved.